• Click on "Blacklist" to configure blacklist for all inbound routes.
• Click on to edit the inbound route.
• Click on to delete the inbound route.
Inbound Rule Configurations
Table 60: Inbound Rule Configuration Parameters
• All patterns are prefixed with the "_".
• Special characters:
X: Any Digit from 0-9.
Z: Any Digit from 1-9.
N: Any Digit from 2-9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-9] - Any digit from 1 to 9.
There are two pattern fields: Pattern and CallerID Pattern.
Pattern: Specifies the pattern that the dialed number must satisfy to use the
inbound route. Example: if the pattern is "_2xxx", the dialed number must be
a four-digit number that starts with 2 in order for this route to be used.
CallerID Pattern: Specifies the callerID pattern that callers must satisfy to
use the inbound route. Example: if the callerID pattern is "_1234", only
callers with a CID of 1234 can use this route.
Notes:
▪ Multiple patterns can be used. Each pattern should be entered in new
line.
▪ Users can add comments to the end of patterns to better organize and
keep track of complex rules by typing “/*” and “*/” before and after each
comment, respectively.
▪ Example:
To Next Page
Loading...
Need help?
General
