NEC Univerge SV8100 - Page 187

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 151
13
Trunk-to-Trunk Transfer
Use this option to enable (1)
or disable (0) loop
supervision for the trunk.
This option is required for
Call Forwarding Off-Premise
and Tandem Trunking only.
0 = Disable (No)
1=Enable (Yes)
0 (OT)
1 (AU)
14
Long Conversation Cutoff
Use this option to enable or
disable the Long
Conversation Cutoff feature
for each trunk.
0 = Disable (No)
1=Enable (Yes)
0 20-21-03
20-21-04
15
Long Conversation Alarm
Before Cutoff
Use this option to enable or
disable the Long
Conversation Alarm for each
trunk.
0 = Disable (No)
1=Enable (Yes)
0 20-21-01
20-21-02
16
Forced Release of Held
Call
Use this option to enable/
disable forced release for
calls on Hold. If enabled, the
system disconnects a call if it
is on Hold longer than a
programmed interval
(Program 24-01-05). If
disabled, forced
disconnection does not
occur. Program 24-01-01
also affects this option.
0 = Disable (No)
1=Enable (Yes)
0 24-01-01
24-01-05
17
Trunk to Trunk Warning
Tone for Long
Conversation Alarm
Use this option to enable or
disable the Warning Tone for
Long Conversation feature
for DISA callers.
0 = Disable (No)
1=Enable (Yes)
0
18
Warning Beep Tone
Signaling
0 = Disable (No)
1=Enable (Yes)
0
19
Privacy Mode Toggle
Option
Use this option to enable or
disable a trunk ability to be
switched from private to non-
private mode by pressing the
line key or Privacy Release
function key.
0 = Disable (No)
1=Enable (Yes)
0
Item
No.
Item Input Data Default
Related
Program