NEC Univerge SV8100 - Page 188

Issue 10.1 UNIVERGE SV8100
2 - 152 Program 14 : Trunk, Basic Setup
20
Block Outgoing Caller ID
Allow (1) or prevent (0) the
system from automatically
blocking outgoing Caller ID
information when a user
places a call. If allowed (i.e.
block, enabled), the system
automatically inserts the
Caller ID block code (defined
in 14-01-21) before the user
dialed digits.
0 = Prevent (No)
1 = Allow (Yes)
0 14-01-21
20-08-15
21
Caller ID Block Code
Enter the code, up to 8 digits,
that should be used as the
Caller ID Block Code. This
code is automatically
inserted before dialed digits if
Program 14-01-20 is set to 1.
Dial (up to eight
digits)
No Setting
(OT)
1831 (AU)
14-01-20
20-08-15
22
Caller ID to Voice Mail
Enable or disable the system
ability to send the Caller ID
digits (Remote Log-On
Protocol) to voice mail.
0 = Disable (No)
1 = Enable (Yes)
0
23
Least Cost Routing
0 = LCR Off
1 = LCR On
2 = LCR On (Cost
Center Code
only)
0
24
Trunk-to-Trunk Outgoing
Caller ID through Mode
Enable (1) or Disable (0) the
ability to send the original
Caller ID through when the
call is Forward Off-Premise.
0 = Disable (No)
1 = Enable (Yes)
0
25
Continued/Discontinued
Trunk-to-Trunk
Conversation
Enable (1) or Disable (0) the
ability to dial a service code
to continue or disconnect the
Trunk-to-Trunk conversation
after the alert tone is heard.
0 = Disable (No)
1 = Enable (Yes)
0 20-28-01
20-28-02
20-28-03
24-02-07
24-02-10
25-07-07
25-07-08
26
Automatic Trunk-to-Trunk
Transfer Mode
0 = Normal Transfer
(Normal)
1 = Step Transfer
(Step)
0 24-02-11
24-02-12
Item
No.
Item Input Data Default
Related
Program