Issue 10.1 UNIVERGE SV8100
2 - 12 Program 10 : System Configuration Setup
09
Dial Information Element
ISDN Protocol definition
Only when Dial Sending Mode
(10-03-08) is set for 1 (Overlap
Sending).
0 = Keypad Facility
1 = Called Party Number
1
10
Master/Slave System (Network
Mode only) (OT)
0 = Slave System
1 = Master System
0
11
Networking System Number
(Network Mode only) (OT)
0 - 50
0
12
--- Not Used ---
13
Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the
system considers this as Loss-Of-
Signal and the PRTA does not come
up. Note that there are different
values based on the setting in 10-03-
12 for the PRI.
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
2
14
Service Protocol for S-point
0 = Keypad facility
1 = Specified Protocol for Aspire
system
0
15
Call Busy Mode for S-point
0 = Alerting
1 = Disconnect
0
16
Two B-Channel Transfer for PRI
Service
0=off
1=on
0
17
ISDN Ringback Tone
If Telco does not provide ringback
tone, SV8100 can if 10-03-17 is set to
1:Enable.
0 = Disable
1=Enable
0
18
Type of Number
ISDN Protocol definition.
Select the number type for the ISDN
circuit.
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
0
19
Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used for
the ISDN circuit.
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering
plan
5 = Private numbering plan
0
Item
No.
Item Input Data Default
To Next Page
Loading...
