PMIPv6 Profiles
A PMIPv6 forwarding profile defines the policy for handling the mobility management of a mobile
node using the proxy mobile IPv6 protocol.
Configuring the Global LMA and MAG Options
Follow these steps to configure the global LMA and MAG.
1. Go to Configuration > Services & Profiles.
2. On the side menu, click Forwarding > PMIPv6.
The PMIPv6 Service Profile page appears.
In the Global LMA & MAG Options section, configure the following sections:
3. In the LMA Failover Options section, configure the following:
• LMA keep-alive interval: Set the number of seconds at which the mobile node will send
an alive notification message to the LMA (local mobility anchor). The default is 30 seconds.
• LMA keep-alive retries: Set the maximum number of attempts that the LMA will send an
echo-request message to the mobile node when the mobile node is not replying. When
the maximum number of retries has been reached, the LMA will declare the mobile node
as unreachable. The default is five retries.
4. In the MAG Options section, configure the following:
• Binding Refresh Time: Set the number of seconds at which the binding entries in the
controller will be refreshed. The default is 300 seconds.
5. Click Apply.
You have completed configuring the global LMA and MAG options for the PMIPv6 service profile.
Creating a PMIPv6 Profile
A PMIPv6 forwarding profile defines the policy for handling the mobility management of a mobile
node using the proxy mobile IPv6 protocol.
Follow these steps to create a PMIPv6 profile.
1. Go to Configuration > Services & Profiles.
2. On the side menu, click Forwarding > PMIPv6.
The PMIPv6 Service Profile page appears.
3. On the PMIPv6 Service Profile page, click Create New.
The Create PMIPv6 Profile form appears.
4. In Name, type a name for the profile that you are creating.
5. In Description, type a short description.
6. In Primary LMA IP, type the IP address of the primary local mobility anchor.
7. In Secondary LMA IP, type the IP address of the secondary local mobility anchor.
8. In MN-ID Options, specify the identifier to use for the mobile node by selecting one of the
following options:
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
199
Configuring Services and Profiles
Working with Profiles
To Next Page
Loading...
