• IPv4 Cluster interface
• Management interface (IPv4 and IPv6)
NOTE: Although it is possible to use DHCP to assign IP address settings to the
management interface automatically, Ruckus Wireless strongly recommends assigning a
static IP address to this interface.
2. Configure the following settings for the IPv4-Control Interface that you want to update.
a) IP Mode: Configure the IP address mode by clicking one of the following options:
• Static: Click this if you want to assign an IP address to this interface manually.
• DHCP: Click this if you want this interface to obtain an IP address automatically from
a DHCP server on the network. After you click this option, most of the options below
it will be grayed out.
b) IP Address: Enter the IP address that you want to the assign to this interface.
c) Subnet Mask: Enter the subnet mask for the IP address above.
d) Gateway: Enter the IP address of the gateway router.
e) Control NAT IP: Enter the NAT IP address.
3. Configure the following settings for the IPv4-Management Interface and the IPv4-Cluster
Interface that you want to update.
a) IP Mode: Configure the IP address mode by clicking one of the following options:
• Static: Click this if you want to assign an IP address to this interface manually.
• DHCP: Click this if you want this interface to obtain an IP address automatically from
a DHCP server on the network. After you click this option, most of the options below
it will be grayed out.
b) IP Address: Enter the IP address that you want to the assign to this interface.
c) Subnet Mask: Enter the subnet mask for the IP address above.
d) Gateway: Enter the IP address of the gateway router.
4. Configure the following settings for the IPv6-Control Interface and the IPv6-Management
Interface that you want to update.
a) IP Mode: Configure the IPv6 address mode by clicking one of the following options:
• Static: Click this if you want to assign an IPv6 address to this interface manually, and
then configure the following:
IP Address: Enter an IPv6 address (global only) with a prefix length (for example,
1234::5678:0:C12/123) is required. Link-local addresses are unsupported.
Gateway: Enter an IPv6 address (global or link-local) without a prefix length. For
example, 1234::5678:0:C12 (global address without a prefix length) and
fe80::5678:0:C12 (link-local address without a prefix length).
• Auto: Click this if you want the interface to obtain its IP address from Router
Advertisements (RAs) or from a DHCPv6 server on the network.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
223
Configuring the System Settings
Configuring Cluster Planes
To Next Page
Loading...
