7. Configure Syslog Options.
• To send events related to APs in this zone to an external syslog server, select the Enable
external syslog server for APs in this zone check box. Additional options appear below.
• Server Address: Type the IP address of the syslog server on the network.
NOTE: The IP address format that you enter here will depend on the AP IP mode that you
selected earlier in this procedure. If you selected IPv4 Only, enter an IPv4 address. If you
selected IPv6 Only, enter an IPv6 address.
• Port: Type the syslog port number on the server.
• Facility: Select the facility level that will be used by the syslog message. Options include
Local0 (default), Local1, Local2, Local3, Local4, Local5, Local6, and Local7.
• Priority: Select the lowest priority level for which events will be sent to the syslog server.
For example, to only receive syslog messages for events with the warning (and higher)
priority, select Warning. To receive syslog messages for all events, select All.
8. Configure the AP SNMP Options: select the Enable AP SNMP check-box to configure the
SNMPv2 and SNMPv3 settings.
9. Configure Advanced Options.
DescriptionOption
If you want to allow outdoor APs that belong
to this zone to use wireless channels that are
Channel Mode
regulated as indoor-use only, select the Allow
indoor channels check box. For more
information, see Channel Mode on page 76.
You can adjust the AP channel to 2.4 GHz or
5 GHz frequencies by selecting the
appropriate check-box.
Auto Channel Selection
Further, you can automatically adjust the AP
to optimize performance by choosing one of
the following:
• Background Scanning : Changes the AP
channel if there is interference.
• ChannelFly: Continuously monitors
potential throughput and changes the AP
channel to minimize interference and
optimize throughput.
If you want APs to evaluate radio channel
usage automatically, enable and configure the
Background Scanning
background scanning settings on both the
2.4GHz and 5GHz radios. By default,
background scanning is enabled on both
radios and is configured to run every 20
seconds.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
36
Managing Ruckus Wireless AP Zones
Working with AP Zones
To Next Page
Loading...
