Ruckus Wireless Virtual SmartZone - Page 38

DescriptionOption
• Report only malicious rogue devices of
type: Select which event types to report.
Events include SSID spoofing, same
network, and MAC spoofing.
• Protect the network from malicious
rogue access points: Select this check
box to automatically protect your network
from network connected rogue APs,
SSID-spoofing APs and MAC-spoofing
APs. When one of these rogue APs is
detected (and this check box is enabled),
the Ruckus Wireless AP automatically
begins sending broadcast
de-authentication messages spoofing the
rogue's BSSID (MAC) to prevent wireless
clients from connecting to the malicious
rogue AP. This option is disabled by
default.
Improve WLAN performance by enabling load
balancing. Load balancing spreads the
Client Load Balancing
wireless client load between nearby access
points, so that one AP does not get
overloaded while another sites idle. Load
balancing must be enabled on a per-radio
basis. To enable load balancing, select the
Enable loading balancing on [2.4GHz or
5GHz] check box, and then set or accept the
default Adjacent Radio Threshold (50dB for
the 2.4GHz radio and 43dB for the 5GHz
radio).
Client band balancing between the 2.4GHz
and 5GHz radio bands is disabled by default
Band Balancing
on all WLANs. To enable band balancing for
this WLAN, select the Enable band balancing
on radios by distributing the clients on 2.4GHz
and 5GHz bands check box, and then set the
percentages of client load that will be
distributed between the 2.4GHz and 5Ghz
bands. For more information, see Band
Balancing on page 77.
To enable LBS service for this AP zone, select
the Enable LBS Service check box, and then
Location Based Service
select an LBS server to use from the
drop-down list. For information on how to add
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
38
Managing Ruckus Wireless AP Zones
Working with AP Zones