• Members: When you are creating a new AP group, this section will be empty. This will be
populated after you select the access points that you want to belong to this AP group.
• Access Points: This section shows all the access points that currently belong to the AP
zone. Select the check boxes before the Member column (which shows the AP MAC
addresses) of each AP that you want to add to the AP group, and then click Add to Group.
The APs you selected appear under the Members section.
7. In Radio Options, if you want to override a setting that has been defined for this zone, select
the Override zone configuration check box for that setting, and then configure that setting
(see the table below for more information about each setting). If you want to preserve the
original configuration of the zone, skip this step.
DescriptionOption
If you want to override the 2.4GHz channel range that has been configured
for the zone to which this AP group belong, select Select the check boxes
Channel Range
(2.4G)
for the channels on which you want the 2.4GHz radios of managed APs
to operate. Channel options include channels 1 to 11. By default, all
channels are selected.
If the country code that is selected in the General Options section of this
page is United States, the Allow DFS channels check boxs appears.
DFS Channels
Selecting this check box adds Dynamic Frequency Selection (DFS)
channels to the list of 5GHz channels (see below) that managed APs can
use indoors and outdoors.
DFS channels, which are special channels allocated for radar signals, can
be used by unlicensed devices (such as APs and wireless clients) if no
radar signals are using them. If radar signals are detected on a DFS
channel that is currently used by devices, those devices will automatically
vacate the channel and use an alternate channel.
Select the check boxes for the channels on which you want the 5GHz
radios of managed indoor APs to operate. If you selected the Allow DFS
Channel Range
(5G) Indoor
channels check box above, the list of channel options includes the DFS
channels.
Select the check boxes for the channels on which you want the 5GHz
radios of managed outdoor APs to operate. If you selected the Allow
Channel Range
(5G) Outdoor
DFS channels check box above, the list of channel options includes the
DFS channels.
Configure the following options:Radio Options
b/g/n (2.4 GHz)
• Channelization: Set the channel width used during transmission to
either 20 or 40 (MHz), or select Auto to set it automatically.
• Channel: Select the channel to use for the b/g/n (2.4GHz) radio, or
select Auto to set it automatically.
• TX Power Adjustment: Select the preferred TX power, if you want to
manually configure the transmit power on the 2.4GHz radio. By default,
TX power is set to Full on the 2.4GHz radio
• WLAN Group: Specify to which WLAN group this AP group belongs.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
46
Managing Ruckus Wireless AP Zones
Working with AP Groups
To Next Page
Loading...
