Ruckus Wireless Virtual SmartZone - Page 47

DescriptionOption
Configure the following options:Radio Options
a/n/c (5GHz)
• Channelization: Set the channel width used during transmission to
either 20, 40, or 80 (MHz), or select Auto to set it automatically.
• Channel (Indoor): Select the indoor channel to use for the a/n/c
(5GHz) radio, or select Auto to set it automatically.
• Channel (Outdoor): Select the outdoor channel to use for the a/n/c
(5GHz) radio, or select Auto to set it automatically.
• TX Power Adjustment: Select the preferred TX power, if you want to
manually configure the transmit power on the 5GHz radio. By default,
TX power is set to Full on the 5GHz radio.
• WLAN Group: Specify to which WLAN group this AP group belongs.
8. In AP SNMP Options, select the Override zone configuration check-box to replace the
AP zone configuration, and select the Enable AP SNMP check-box to configure the SNMP
settings.
9. In Model Specific Options, configure LED, LLDP, and port settings of all APs of each specific
model that are members of the AP group.
See Modifying Model Specific Controls.
10. In Advanced Options, select the Override zone config check boxes for the settings that
you want to override, and then configure them.
• Location Based Service: To disable the LBS service for this AP group, clear the Enable
LBS service check box. To use a different LBS server for this AP group, select the Enable
LBS service check box, and then select the LBS server that you want to use from the
drop-down list.
• Hotspot 2.0 Venue Profile: If you have configured Hotspot 2.0 venue profiles, select the
profile that you want to assign to this AP group.
• AP Management VLAN: To override the management VLAN tag that has been configured
on the AP, click VLAN ID, and then type the VLAN ID that you want to assign (valid range
is from 1 to 4094). To keep the same management VLAN ID that has been configured on
the AP, click Keep AP's settings
• Client Admission Control: Set the load thresholds on the AP at which it will stop accepting
new clients. See Configuring Client Admission Control.
11. Click OK.
You have completed creating an AP group.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
47
Managing Ruckus Wireless AP Zones
Working with AP Groups