• Mgmt Tx Rate: To set the transmit rate for management frame, select a value (in Mbps)
from the drop-down list.
• DiffServ Profile: To apply a DiffServ profile to this WLAN service, select a profile from the
drop-down menu. Select Disable from the drop-down menu if you want to disable the
profile for the WLAN service.
• Service Schedule: Use the Service Schedule tool to control which hours of the day, or
days of the week to enable/disable WLAN service. Options include:
• Always On: Click this enable this WLAN at all times.
• Always Off: Click this option to disable the WLAN service at all times.
• Specific: Click this to set specific hours during which this WLAN will be enabled. For
example, a WLAN for student use at a school can be configured to provide wireless
access only during school hours. Click on a day of the week to enable/disable this
WLAN for the entire day. Colored cells indicate WLAN enabled. Click and drag to select
specific times of day. You can also disable a WLAN temporarily for testing purposes,
for example.
• Band Balancing: To disable band balancing on this WLAN, select the Do not perform band
balancing for this WLAN service check box. For more information, see Band Balancing
on page 77.
• QoS Map Set: All networks have their own network layer packet marking practices and
it would vary from one network to the other. Therefore, enabling QOS Map Set remaps
the network layer packet marking practice with a common service level.
Select the QOS Map Set check-box to map the Differentiated Services Code Point (DSCP)
range and exception values to the 802.11 packet User Priority (UP).
UP value ranges from 0 – 7 and DSCP value from 0 - 63.
NOTE:
A UP with 255 as its DSCP low and high value is not used.
The DSCP exception value is unique to a UP and cannot be assigned to another UP.
• SSID Rate Limiting: Select the Enable check-box to enable uplink and downlink, and type
the limiting rate for them.
• DNS Server Profile: To apply a DNS Server profile to this WLAN service, select a profile
from the drop-down menu. Select Disable from the drop-down menu if you want to disable
the DNS Server profile for the WLAN service.
15. Click OK at the bottom of the form.
You have completed creating and configuring a WLAN service of the AP zone.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
75
Managing Ruckus Wireless AP Zones
Working with WLANs and WLAN Groups
To Next Page
Loading...
