can the designated AP can receive all the multicast Bonjour protocol packets from other
VLANs.
• Dynamic VLANs are not supported.
• Some AP models are incompatible with this feature due to memory requirements.
Follow these steps to create rules for an AP that will bridge Bonjour
®
services across VLANs.
1. Go to Configuration > AP Zones.
2. On the AP Zone List page, click the zone name for which you want to configure the Bonjour
®
gateway.
3. On the AP Zones sidebar, click Bonjour Policy.
4. Click Create New to create a Bonjour gateway policy.
The Create Bonjour Policy form appears.
5. In Name, type a name for the policy.
6. In Description, type a description for the policy.
7. In the Rules section, click Create New to create a rule.
8. Configure the following options:
• Bridge Service: Select the Bonjour
®
service from the list.
• From VLAN: Select the VLAN from which the Bonjour
®
service will be advertised.
• To VLAN: Select the VLAN to which the service should be made available.
• Notes: Add optional notes for this rule.
9. Click Save to save the rule.
10. To create another rule, repeat steps 7 on page 90 to 9 on page 90.
11. After you finish creating all rules that you require, click OK to close the Create Bonjour Policy
form.
12. Select the Enable Bonjour gateway on the AP check box.
You have completed creating a Bonjour
®
gateway policy.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
90
Managing Ruckus Wireless AP Zones
Working with Bonjour Policies
To Next Page
Loading...
Need help?
General
