DescriptionOption
• Port-based Authenticator: If you select this authenticator, only a
single MAC host must be authenticated for all hosts to be granted
access to the network.
This section only appears when 802.1X is set to either MAC-based
Authenticator or Port-based Authenticator.
Authenticator
Select the authentication server to use. If you want to use the controller
as proxy, select the Use the Controller as Proxy check box instead.
Authentication
Server
Select the accounting server to use. If you want to use the controller
as proxy, select the Use the Controller as Proxy check box instead.
Accounting Server
Select this check box to allow AAA server queries using the MAC
address as both the user name and password. If MAC authentication
Enable MAC
authentication
bypass is unsuccessful, the normal 802.1X authentication exchange will be
attempted.
5. Click OK.
The page refreshes, and then the profile you created appears on the list of Ethernet port profiles.
You can now use this profile to configure the port settings of specific AP models. See Configuring
Model Based Settings on page 48.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
95
Managing Ruckus Wireless AP Zones
Creating an Ethernet Port Profile
To Next Page
Loading...
