Xerox Phaser 6300 Service Manual

Error Messages and Codes 3-39
Replace Fuser
The Fuser Life counter indicates that the Fuser has reached its end of life. Fuser
replacement is necessary to avoid print quality problems.
Note
There is no hard stop associated with the Replace Fuser message.
Applicable Status Code:
Code 207: Replace Fuser
Initial Actions:
■ Print the Supplies Usage page to verify remaining life and Fuser install date.
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Cycle power to the printer.
Does the error persist?
Go to Step 2. Complete
2
Check the Fuser for damage.
Is the Fuser damaged?
Replace the Fuser,
then cycle power.
Go to Step 3.
3
Check Fuser resistance.
1. Remove the Fuser.
2. Disconnect J361.
3. Is the resistance between P361-B5 <=>
P361-B4 less than 400KΩ?
4. Is the resistance between P361-B5 <=>
P361-B4 less than 7MΩ?
Go to Step 4. Replace the
Fuser
(
page 8-67).
4
Check all pins on the FSR/ADC Harness
PL5.2.28 for continuity.
1. Disconnect P/J36 and J361.
2. Check continuity between J36 <=> J361.
Replace the Engine
Control Board
(
page 8-104).
Replace the
FSR/ADC
Harness.

Xerox Phaser 6300 Specifications

General

Brand	Xerox
Model	Phaser 6300
Category	Printer
Language	English