Xerox Phaser 6300 - Error Messages and Codes; Control Panel Message

Error Messages and Codes 3-7
Consumable/Routine Maintenance Item Errors (Continued)
Install or Lock [C][M][Y][K] Toner Cartridge 208, 209, 210, 211 3-41
Install or Reseat Imaging Unit 212 3-33
Install or Reseat Transfer Roller 213 3-35
Install or Reseat Fuser 214 3-38
Remove Ribbon from [C][M][Y][K] Toner Cartridge;
Unlock And Lock Cartridge To Clear
215, 216, 217, 218 3-45
Metered Toner is not Enabled 223 3-53
Replace [C][M][Y][K] Toner Cartridge 224, 225, 226, 227 3-42
Tray and Media Errors
Insert Tray 2
Insert Tray [3][4][5]
160
161, 162, 163
3-54
3-55
Out of Paper Load Tray 1(MPT) with [size] [type]
Out of Paper Load Tray [2][3][4][5] with [size] [type]
165
166, 167, 168, 169
3-57
3-58
Output Tray is Full, Unload Paper 191 3-60
Media Mismatch Errors
Wrong Paper Size Load Tray 1 (MPT) with [size] [type]
Wrong Paper Size Load Tray [2][3][4][5] with [size] [type]
176
177, 178, 179, 180
3-61
3-63
Configuration Errors
Invalid Configuration Card _ 3-64
Configuration Card Missing _ 3-64
Fatal Errors
Laser Failure [code] 7, 8, 9, 10, 11 3-66
Density Sensor Failure [code] 13, 14, 15, 16 3-67
Fuser Failure [code]
Fuser Failure 44
Fuser Failure [code]
40, 41, 42, 43
44
45, 46, 47
3-68
3-69
3-70
Fuser Fan Failure 50 3-71
Rear Fan Failure 51 3-72
Fan Failure 52 3-73
Fuser Firmware Failure 76 3-74
Engine Firmware Failure [code]
Engine Firmware Failure [code]
70, 71, 73, 74, 79
72, 78
3-75
3-75
Image Density Error 77 3-84
Error Message Summary (Continued)
Control Panel Message Code Go to Page