Xerox Phaser 6300 Service Manual

8-4 Phaser 6300/6350 Color Laser Printer Service Manual
Fastener Types
The following table lists the primary types of Posi-Drive screws used to assemble the
printer. The procedures provide dimensional specifications for screws being removed.
Caution
Use care when installing self-tapping screws in plastic. To properly start the
screw in plastic, turn the screw counter-clockwise in the hole until you feel the
screw engage the threads, then tighten as usual. Failure to properly align or over
tighten the screw can result in damage to previously tapped threads.
Posi-Drive Screw Types used in the Printer
Type Application Shape Characteristics
Self-tapping,
plastic
1. Silver colored
2. Screw thread is coarse
compared to metal screw.
3. Screw tip is thin.
Self-tapping,
plastic
1. Black colored
2. Screw thread is coarse
compared to metal screw.
3. Screw tip is thin.
Self-tapping,
plastic with
flange
1. Silver colored
2. It has a flange.
3. Screw thread is coarse
compared to metal screw.
4. Screw tip is thin
Sheet Metal,
silver
1. Silver colored
2. Diameter is uniform
3. Typically 6 mm in length
Sheet Metal.
with flange
1. Silver colored
2. It has a flange.
3. Diameter is uniform
Sheet Metal,
silver with
lock washer
1. Silver colored
2. Includes a toothed washer
3. Diameter is uniform
4. Used for grounding terminals.
Parts etc Plastic
Coarse
Parts etc Plastic
Coarse
Parts etc Plastic
Coarse
Parts etc Sheet metal
Parts etc Sheet metal
Parts etc Sheet metal

Xerox Phaser 6300 Specifications

General

Brand	Xerox
Model	Phaser 6300
Category	Printer
Language	English