Xerox Phaser 6300 - Specifications; Memory Specifications; Electrical Specifications

1-12 Phaser 6300/6350 Color Laser Printer Service Manual
Life ratings are based on A-size sheets at 5% coverage. Imaging Unit life ratings are
based on average 4 page job length.
Specifications
Memory Specifications
Electrical Specifications
Toner Cartridges Print Life
Black-Capacity
Color Capacity
Metered (PagePack) Capacity (all colors)
4000, 7000 or (10,000 for 6350-only)
4000, 7000 or (10,000 for 6350-only)
10,000 (6300 or 6350)
Maintenance Items
Imaging Unit 35,000
Fuser 100,000
Transfer Roller and Waste Box 35,000
Feed Roller Kit up to 100,000
Long-Life Maintenance Kit up to 300,000
Characteristic Specification
Minimum RAM 256 MB
Maximum RAM 1 GB
Supported RAM SODIMM 200-pin module of 256 or 512 MB. All combinations are allowed
for configurations of 256, 512, 768 MB, and 1 GB.
NVRAM Single chip of either PPROM or StrataFlash 16 MB
Characteristic Specification
Primary line
voltages
110-127 V Printer - (90 - 135 V) 13 amp circuit
220-240 V Printer - (198 - 254 V) 7-8 amp circuit
Primary line
voltage
frequency range
100-120 V Printer - 50/60 Hz + 3 Hz
220-240 V Printer - 50/60 Hz + 3 Hz
NOTE: Power the printer directly
from the wall outlet. Do not
use “Power Strips” as they
may limit available current.
In-rush Current
100A, and 10m sec (half cycle) or less. at rated voltage: ±10%
Power
consumption at
rated voltage
input
Mode
Print Mode
Ready Mode
Sleep Mode
Condition
Maximum
Fuser On
Fuser Off
100/120 VAC
1300 W or less
180 W or less
45 W or less
220/240 VAC
1300 W or less
180 W or less
45 W or less