Service Parts Disassembly 8-99
LVPS (PL9.1.4)
The Low Voltage Power Supply (LVPS) assembly consists of the power supply,
attached power switch, the AC Inlet Harness, and the surrounding enclosure.
1. Remove the Top Main Cover (page 8-8).
2. Remove the Right Side Cover (page 8-12).
3. Remove the Left Side Cover (page 8-13).
4. Remove the Rear Cover (page 8-16).
5. Unplug connectors (P/J161, 162, 163, 164, 165) from the LVPS.
6. Remove the 2 screws (metal, 6 mm) that secure the LVPS to the Toner Cartridge
Holder Assembly.
7. Remove the 3 screws (metal, 6 mm) that secure the LVPS to the printer chassis.
8. Remove the screw (self-tapping, plastic 10mm) located at the bottom of the
LVPS, that secures it to Tray 2.
9. Remove the harnesses from the Rear Cable Guide.
10. Remove the screw (self-tapping, plastic 10mm) that secures the Power Switch
Link Shaft support and remove the support.
Note
In the step below, do not remove the Switch Link Shaft from the printer.
10. Release the Power Switch Link Shaft from the notch in the LVPS and lift up to
remove the LVPS.
Replacement Note
Align the bosses at the base of the LVPS to those on the frame. Also, P/J167
has no connection.
To Next Page
Loading...
Need help?
General