Xerox Phaser 6300 Service Manual

1-16 Phaser 6300/6350 Color Laser Printer Service Manual
Environmental Specifications
First Print Output Time
First Print Output Time (FPOT) is defined as a time from reciept of the print
command in Ready mode until the first page sourced from either Tray 1 or Tray 2 is
delivered to the Output Tray. Sourcing media from the optional trays increases FPOT.
Note
This does not include the execution times for the Boot Loader or POST which
vary depending on printer configuration.
These conditions apply to the values in the table above:
* At Fuser ready and Laser Unit Motor is rotating normally.
** At Fuser stand-by and Laser Unit Motor Off.
A4 SEF paper
Plain paper mode
Characteristic Specification
Temperature:
Operating
Optimal Print Quality Range
5
o
C to 32
o
C (41
o
F to 90
o
F)
15
o
-28
o
C (60
o
to 82
o
F)
Storage
12 month maximum
48 hours maximum
Normal: 0
o
C to 35
o
C (32
o
F to 95
o
F), at 15% - 85% RH
Severe: -20
o
C to 40
o
C (-4
o
F to 104
o
F) at 5% - 95% RH
Humidity (RH)
Operating
Optimal Print Quality Range
15% - 85% RH
20% to 70% RH
Altitude
Operating
Transportation
0 - 3,100 meters (10,170 ft.)
0 - 15,000 meters (30,000 ft.) in pressurized containers.
Acoustic Noise (Lwa)
Idle
Printing
Printer Only With Feeder Option
5.0 B or less 5.0 B or less
6.65 B or less (Full Speed) 7.35 B or less (Full Speed)
6.65 B or less (Half Speed) 7.30 B or less (Half Speed)
Process Speed
First Print Out Time (seconds)
Simplex Duplex
Laser Unit Ready* Laser Unit Off** Laser Unit Ready* Laser Unit Off**
Full 6.0 10.5 10.0 14.5
High 8.0 12.5 13.5 18.0
Mid 10.5 15.0 17.5 22.0
Low 15.0 19.5 25.5 30.0

Xerox Phaser 6300 Specifications

General

Brand	Xerox
Model	Phaser 6300
Category	Printer
Language	English