Service Parts Disassembly 8-101
Interlock Switch (PL9.1.11)
1. Remove the Top Main Cover (page 8-8).
2. Remove the Right Side Cover (page 8-12).
3. Unplug the Interlock Switch connector (P/J161) from the LVPS.
4. Remove the Interlock Switch harness from the clamp on the LVPS.
5. Release the two clamps on the Developer Drive Assembly that secure the
Interlock Switch harness.
6. Remove the Developer Drive Assembly (page 8-93).
7. Remove the Interlock Switch from the printer.
Replacement Note
Position the Interlock Switch on the boss provided on the frame. Also, when
replacing the motor, rotate the motor housing to engage the drive gears.
Verify that the gears are engaged before installing the screws.
s6300-216
P/J161
Interlock
Switch
To Next Page
Loading...
Need help?
General