Error Messages and Codes 3-51
Replace Maintenance Kit
The Printer detected an error condition that indicates the parts listed below need to be
replaced. This will ensure the rated engine life of 600,000 prints is achievable.
Applicable Status Code:
Code 101: Replace Maintenance Kit
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Check the Fuser part number.
Is the Fuser a genuine Xerox part.
Go to Step 2. Replace the Fuser
(
page 8-5).
2
Check the Fuser for damage.
Is the Fuser damaged?
Replace the Fuser. Go to Step 3.
3
Check Fuser installation.
Remove and reinstall the Fuser.
Does the error persist?
Go to Step 4 Complete
4
Replace the Fuser.
Does the error persist?
Go to Step 5. Complete
5
Check all pins on the FSR/ADC Harness
PL5.2.28 for continuity.
1. Disconnect P/J36 and P/J361.
2. Check continuity between J36<=>J361.
Replace the Engine
Control Board
(
page 8-104).
Replace the FSR/
ADC Harness.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
■ Long-Life Maintenance Kit, 650-4360-00
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Follow the procedure starting on page 7-4
and replace all concerned parts.
Have all parts outlined in the procedure
been replaced?
Go to the Hidden
Service menu on
the Control Panel
and Reset the
Maintenance Kit
Life count.
Replace all
concerned parts.
To Next Page
Loading...
