8-90 Phaser 6300/6350 Color Laser Printer Service Manual
Toner Cartridge Holder Assembly
Complete removal of the Toner Cartridge Holder Assembly is not required to access
the upper most Laser Unit screw. Use the following procedure to loosen the assembly
and lift it approximately 0.5 inch it to allow access to the Laser Unit screw without
disconnecting the Auger Tubes or removing the Toner Cartridges.
arn
ng
Be sure to clean up any residual toner on the Toner Cartridge Holder Assembly
with a dedicated toner vacuum cleaner. Do not clean up toner with a general-
purpose vacuum cleaner to avoid the risk of explosion by igniting the fine
powder. As an additional precaution, be sure to attach a ground cable to the toner
vacuum cleaner to discharge static electricity.
Caution
Take care not to allow toner dust to adhere to the photo sensors located on the
Toner Cartridge Holder Assembly. Toner adhering to the photo sensors reduces
their efficiency and could cause erroneous errors.
1. Remove the Top Main Cover (page 8-8).
Note
To control Toner spillage, after removing the Top Main Cover, replace the Toner
Cartridges and lock them into place.
2. Remove the Right Side Cover (page 8-12).
3. Remove the Left Side Cover (page 8-13).
4. Remove the Rear Cover (page 8-16).
5. Remove the 2 wires (red) from the harness guide on the CRUM Reader.
To Next Page
Loading...
Need help?
General