Service Parts Disassembly 8-93
Drive
Developer Drive Assembly (PL8.1.1)
1. Remove the Top Main Cover (page 8-8).
2. Remove the Right Side Cover (page 8-12).
3. Remove the four Harness Guide Clamps from the Rear Harness Guide and
remove the harnesses.
4. Release the clamps on the Developer Drive Assembly and remove the Interlock
Switch harness.
5. Remove the 2 screws (silver, tap 10 mm) that secure the Rear Harness Guide and
move the guide to the rear to release the front hook from the Developer Drive
Assembly.
6. Remove the Rear Harness Guide.
s6300-209
Developer Drive Assembly
Rear Harness Guide
Clamps
To Next Page
Loading...
Need help?
General