Error Messages and Codes 3-11
Jam Error Procedures
Jam at Fuser: Jam F
Paper did not reach the Exit Sensor on time or the Exit Sensor indicates that paper
remains in the Fuser Exit Roller.
Applicable Status Code:
Code 152: Jam at Fuser
Initial Actions:
■ Remove the Fuser and check for any obstructions, media, damage, or debris.
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
arn
ng
To avoid the potential of electric shock, ensure the power to the printer is off
and the power cord is disconnected from the wall outlet prior to performing
Step 2 of the following troubleshooting procedure.
Caution
Allow adequate time for the Fuser to cool before servicing the printer.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
■ Fuser, PL5.1.1
■ Exit Sensor Actuator, PL5.1.2
■ Fuser Drive Assembly, PL5.2.25
■ Print Engine LVPS and Drive P/J Locator (page 10-6)
■ Print Engine Drive Wiring Diagram (page 10-19)
■ Print Engine Fuser Wiring (page 10-22)
To Next Page
Loading...
