Service Parts Disassembly 8-103
EEPROM Board (PL9.1.12)
1. Remove the Top Main Cover (page 8-8).
2. Remove the Right Side Cover (page 8-12).
3. Remove the 4 clamps that hold the harness in the Rear Harness Guide and
remove the harness.
4. Remove the 2 screws (self-tapping, plastic 10 mm) that secure the Rear Harness
Guide.
5. Unplug connector (P/J144) from the EEPROM Board.
6. Remove the screw (self-tapping, plastic 10 mm) that secures the EEPROM Board
and remove.
s6300-217
Rear Harness Guide
Clamps
P/J144
EEPROM Board
To Next Page
Loading...
