Xerox Phaser 6300 - Chute Assembly in (PL5.2.1)

8-58 Phaser 6300/6350 Color Laser Printer Service Manual
Chute Assembly In (PL5.2.1)
1. Remove the Top Main Cover (page 8-8).
2. Remove the Front Cover (page 8-10).
3. Remove the Right Front Cover (page 8-17).
4. Remove the Left Front Cover (page 8-18).
5. Remove the Right Side Cover (page 8-12).
6. Remove the Left Side Cover (page 8-13).
7. Remove Tray 1 (MPT) (page 8-39).
8. Remove the Tray 1 (MPT) Cover (page 8-40).
9. Remove the Fuser (page 8-67).
10. Remove the Transfer Roller (page 8-70).
11. Remove the Chute Assembly Out (page 8-61).
12. Remove a screw (silver, provided with external tooth washer, 5 mm) that secures
the ground wire on the right side of the bottom plate.
13. Unplug connector (P/J162) from the LVPS.
14. Remove the the Harness Guide Clamp from the Rear Harness Guide.
15. Remove the two screws (self-tapping, plastic 10 mm) that secure the Front
Harness Guide and remove the guide.