Xerox Phaser 6300 - Page 535

A-14 Phaser 6300/6350 Color Laser Printer Service Manual
Rear Fan High Speed
Low Speed
High Speed Continuous
Low Speed Continuous
Audible verification of motor
function.
Check for airflow.
Fuser Fan High Speed
Low Speed
High Speed Continuous
Low Speed Continuous
Audible verification of motor
functionality.
Check for airflow.
Sensor/Switch Tests - Tests the functionality of the sensors and switches.
Interlock Switch Sensor is On
Sensor is Off
Door A or B is open
Door A or B is closed
Registration Sensor Sensor is Off
Sensor is On
This test continuously cycles
paper. The sensor state changes
as paper passes the sensor.
NOTE: This test can also be used
as a paper path transport
test when troubleshooting
Jam conditions.
Exit Sensor Sensor is Off
Sensor is On
Move the Exit Actuator (PL5.1.2) to
toggle the sensor state.
Duplex Sensor Sensor is Off
Sensor is On
Move the Duplex Jam Actuator
(PL5.4.13) to toggle the sensor.
Full Stack Sensor Sensor is Off
Sensor is On
Move the Full Stack Actuator
(PL5.4.2) to toggle the sensor.
[Y][M][C][K] Toner
Low
Toner is Low
Toner is NOT Low
Displays current state of the
sensor.
[Y][M][C][K] Toner
Cartridge Present
Sensor is Off
Sensor is On
Move the Toner Cartridge In switch
(PL7.2.7) to change the sensor.
Toner Cartridge is LOCKED.
Toner Cartridge is UNLOCKED.
[Y][M][C][K] CRUM
Sensor
Sensor is Off
Sensor is On
Move the Toner Cartridge In switch
(PL7.2.7) to change the sensor.
Toner Cartridge is LOCKED.
Toner Cartridge is UNLOCKED.
Tray [2] [3] [4] [5]
Low Paper Sensor
Size: XXXX
Paper is Not Low
Paper is Low
Move the Tray Rear Guide or
maunally toggle the Paper Size
Switch Acutators to the desired
paper size and verify the sensor
output.
Fill tray with paper to the fill line.
Insert one sheet of paper in tray to
change the sensor.
Service Diagnostics Tests and Utilities (Continued)
Test Control Panel Display and Test Definition