Xerox Phaser 6300 - Page 545

I-4 Phaser 6300/6350 Color Laser Printer Service Manual
Engine Control Board, 2-49
connectors
, 10-7
fault isolation
, 4-5
firmware failure error
, 3-7
location
, 2-48
NVRAM
failure error
, 3-8
location
, 8-107
removal
, 8-107
part number
, 9-35
removal
, 8-104
save/restore data
, A-16
engine error history
, 3-3
engine error log
, 3-3
display
, 3-3
format
, 3-3
engine test print
, 5-9
enhanced mode
, 2-6
envelopes
supported sizes
, 1-17
error message summary
, 3-6
error messages
abbreviations used
, 3-5
Control Panel
, 3-6
fatal errors
, 3-7
jam errors
, 3-6
list of errors
, 3-6
POST
, 4-3
printer status
, A-4
Status page
, 3-3
warnings
, 3-8
Ethernet Port
, 1-2
configuration
, 6-5
location
, 1-7
operational testing
, 4-23, 4-26
POST testing
, 4-3
F
Fan
Fuser Fan
, 2-37
connector location
, 10-5
fan failure error
, 3-7
part number
, 9-23
removal
, 8-66
wiring
, 10-19
Rear Fan
, 2-48
connector location
, 10-6
failure error
, 3-7
part number
, 9-5
removal
, 8-102
wiring
, 10-17
testing
, A-12
fasteners
Hardware Kit
, 9-63
harness guide clamps
, 9-35
precautions
, 8-3
screws
, 8-4
fatal errors
, 3-7
Feed Roller
life count
, 1-12
location
, 1-10
operation
, 2-41
removal
, 8-32
Tray 1 (MPT)
location
, 2-34
part number
, 9-23
Feed Roller Kit
contents
, 9-60
part number
, 9-58
Feed Solenoid
, 2-42
Feeder Chute
part number
, 9-9
removal
, 8-21
fonts
reset defaults
, 6-6
supplied fonts
, 1-2
Front Cover
part number
, 9-5
removal
, 8-10
Full Stack Sensor
, 2-34
actuator removal
, 8-53
connector location
, 10-5
location
, 2-20
output tray full error
, 3-7
part number
, 9-25
removal
, 8-52
testing
, A-14
wiring
, 10-26
Fuser
, 2-37
belt
, 2-38
components
, 2-38