3Com 5500G-EI - Page 340

320 CHAPTER 9: USING FABRIC COMMANDS
Use the undo sysname command to restore the default fabric name.
Example
Change the fabric name of the device to "building1".
<SW5500>display xrn-fabric
Fabric name(HostName): SW5500, Fabric authentication: md5
Fabric mode : L3, Fabric unit number: 2
Unit Name Unit ID
First 1
Second 2
[SW5500]sysname building1
<building1>display xrn-fabric
Fabric name(HostName): building1, Fabric authentication: md5
Fabric mode : L3, Fabric unit number: 2
Unit Name Unit ID
First 1
Second 2