Fujitsu Oracle SPARC M12-2 User Manual

Table 4-29
Inactive/Cold Replacement Procedure of the XSCFU (continued)
Work
Order
Task Reference
3 Confirming that the XSCFU to be
replaced is the standby or slave XSCF and
is currently replaceable (*1)
"Table 2-16 XSCFU LEDs and Their
States"
4 Powering off the physical partition
containing the SPARC M12-2S that
houses the XSCFU to be replaced
"9.5.1 Stopping a Specific Physical
Partition"
5 Switching the mode switch
on the OPNL
to Service
"2.3.2 OPNL Control Function"
6 Releasing the SPARC M12-2S requiring
maintenance from the building block
configuration
"9.6.1 Releasing the SPARC M12-2S
From the Building Block Configuration"
7Placing the SPARC M12-2S requiring
maintenance into the cold state
"9.8.2 Removing the Power Cords"
8Removing the XSCFU from the
SPARC
M12-2S
"11.4 Removing the XSCFU"
9 Switching the SD card (*2) "11.5 Switching an SD Card"
10
Installing the XSCFU in the SPARC M12-2S "11.6 Installing the XSCFU"
11 Placing the SPARC M12-2S that required
maintenance into the hot state
"10.1.1 Installing a Power Cord"
12 Incorporating the SPARC M12-2S that
required maintenance into the building
block configuration
"10.4.1 Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
13 Confirming that there is no problem with
the
replacement XSCFU
"10.5.3 Checking the FRU Status After
Maintenance"
14 Switching the mode switch on the OPNL
to Locked, and powering on the physical
partition containing the SPARC M12-2S
that has undergone maintenance
"10.8 Powering on a Physical Partition"
15 Checking the operating condition of the
system
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
*1 Before replacing the XSCFU, confirm that the READY LED of the XSCFU is lit in green or off. If the READY
LED of the XSCFU is blinking, wait until the LED stays lit or is turned off.
- If the XSCFU requiring replacement is not running when the physical partition
containing the XSCFU is
powered on, perform active/hot replacement.
- If the physical partition containing the XSCFU requiring replacement is powered off, you can perform hot
replacement of the XSCFU even when it is not running. In that case, proceed to step 5.
*2 If the SD card installed in the
maintenance part will be used, this work is not required.
Chapter 4 FRU Replacement Workflows 105

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English