Fujitsu Oracle SPARC M12-2 User Manual

primary-vsw0@primary 00:14:4f:fb:e1:a8 1 1500
NAME SERVICE ID DEVICE MAC MODE PVID
VID MTU
MAXBW LINKPROP
vnet1
primary-vsw4@primary 1 network@1 00:14:4f:fb:4d:fe 1
1500
PEER MAC MODE PVID VID MTU MAXBW
LINKPROP
primary-vsw4@primary 00:14:4f:f8:42:2f 1 1500
DISK
NAME VOLUME TOUT ID DEVICE SERVER MPGROUP
vdisk00 vdisk00@primary-vds0 0 disk@0 primary
(Omitted)
primary#
ldm list-bindings ldom
(Omitted)
IO
DEVICE PSEUDONYM OPTIONS
pci@8600 PCIE6
pci@8a00
PCIE10
pci@8600/pci@4/pci@0/pci@9 /BB0/PCI5
pci@8600/pci@4/pci@0/pci@11 /BB0/PCI6
pci@8a00/pci@4/pci@0/pci@0
/BB1/PCI3
pci@8a00/pci@4/pci@0/pci@8 /BB1/PCI4
pci@8a00/pci@4/pci@0/pci@9 /BB1/PCI5
pci@8a00/pci@4/pci@0/pci@11 /BB1/PCI6
DISK
NAME VOLUME TOUT ID DEVICE SERVER MPGROUP
vdisk10 vdisk10@primary-vds0 0 disk@0 primary
vdisk11 vdisk11@primary-vds0 1 disk@1 primary
vol_iso vol_iso@primary-vds0 2 disk@2 primary
(Omitted)
# ldm list-socket
CONSTRAINTS
DOMAIN SOCKET_ID STATE
primary 0, 2 active
...
Check whether CPU socket constraints are used.
The CPU socket constraint settings are not restored even if addboard -m
bind=resource is executed. Therefore, you need to set the constraints again by
using the ldm command after executing addboard.
CPU socket constraints are used if the domain information is output below
CONSTRAINTS.
7.
Check
the assignment status of I/O devices.
Check I/O devices and assigned logical domain names. In this example, the I/O
devices of BB#01 were not assigned to the logical domain beforehand to use the
physical partition dynamic reconfiguration (PPAR DR) function to release BB#01.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023300

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English