Fujitsu Oracle SPARC M12-2 User Manual

export/ovm/vdisk10
vdisk11
/dev/zvol/dsk/rpool/
export/ovm/vdisk11
Physical LAN Port Mounting Location
net0 to net3 BB#00 on-board LAN
net4 to net7 BB#01 on-board LAN
primary#
dladm show-phys -L
LINK DEVICE LOC
net0
ixgbe0 /BB0/CMUL
net1 ixgbe1 /BB0/CMUL
net2 ixgbe2 /BB0/CMUU
net3 ixgbe3 /BB0/CMUU
net4
ixgbe4 /BB1/CMUL
net5 ixgbe5 /BB1/CMUL
net6 ixgbe6 /BB1/CMUL
net7 ixgbe7 /BB1/CMUL
(Omitted)
primary#
ldm list-bindings guest
(Omitted)
NETWORK
NAME SERVICE ID DEVICE MAC MODE PVID
VID MTU
MAXBW LINKPROP
vnet0 primary-vsw0@primary 0 network@0 00:14:4f:f9:58:4e 1
1500
PEER MAC MODE PVID VID MTU MAXBW
LINKPROP
5.
Check the mounting locations of the physical LAN ports.
This example checks in advance that Oracle Solaris on the control domain does
not use net4 to net7, to release BB#01 using PPAR DR.
6.
Check the resources assigned to the logical domain guest and the logical
domain ldom.
The virtual network devices
vnet0 and vnet1 are assigned to the logical domain
guest. From the results of steps 4 to 6, you can also see that vnet0 uses the
physical LAN port net0 of BB#00 and vnet1 uses the physical LAN port net4 of
BB#01. In this example, the assignment of vnet1 is released
from the logical
domain guest beforehand in order to use the physical partition dynamic
reconfiguration (PPAR DR) function to release BB#01.
From the assigned I/O resources, you can see that the logical domain ldom is the
root domain configured by the root complexes of BB#00 and BB#01. In this
example, the
assignment of PCIE10 (pci@8a00) is released from the logical
domain ldom beforehand in order to use the physical partition dynamic
reconfiguration (PPAR DR) function to release BB#01.
Chapter 9 Releasing FRUs From the System 299

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English