Fujitsu Oracle SPARC M12-2 - Page 387

Table 10-4
Procedure for Incorporating the SR-IOV Virtual Function (VF)
-: Unnecessary
Item Task Command Dynamic
SR-IOV
Function Used
Static SR-IOV
Function Used
1 Checking whether the SR-IOV
virtual function can be created
ldm list-io
2
Setting the delayed reconfiguration
mode for the control domain or
root domain to which the
physical function (PF) of
SR-IOV is assigned
ldm start-reconf
<domain-name>
- Necessary
3 Creating the SR-IOV virtual
function
ldm create-vf <pf_name> Necessary Necessary
4 Confirming that the SR-IOV
virtual function was created
ldm list-io
5 Restarting Oracle Solaris on the
control domain or service
domain for which
the delayed
reconfiguration mode has been
set
For the control domain
shutdown -i6 -g0 -y
For the root domain
ldm stop-domain -r
<domain-name>
- Necessary
6 Stopping the logical domain to
which the SR-IOV virtual
function is assigned
ldm stop-domain
<domain-name>
- Necessary
7 Assigning the SR-IOV virtual
function to a logical domain
ldm add-io <vf_name>
<domain_name>
Necessary Necessary
8Starting the logical domain to
which the SR-IOV virtual
function was assigned
ldm start-domain
<domain-name>
- Necessary
9 Confirming that the SR-IOV
virtual function is assigned to
the logical domain
ldm list-io
primary
# ldm list-io
NAME TYPE BUS DOMAIN STATUS
---- ---- --- ------ ------
<Omitted>
/BB0/PCI5/IOVNET.PF0 PF PCIE3 primary
^^^^^^^^^^^^^^^^^^^^^^^^^^^^
/BB0/PCI5/IOVNET.PF1 PF PCIE3 priamry
/BB0/PCI5/IOVNET.PF2 PF PCIE3 primary
/BB0/PCI5/IOVNET.PF3 PF PCIE3 primary
<Omitted>
primary#
1.
Check whether the SR-IOV virtual function can be created.
This example checks that the SR-IOV virtual function can be created with the
PCIe card mounted in PCI#5 of BB#00.
Chapter 10 Setting Up the System 365