GigaDevice Semiconductor GD32F3x0 - Page 85

GD32F3x0 User Manual
85
10
IRC8MSTBIE
IRC8M Stabilization Interrupt Enable
Set and reset by software to enable/disable the IRC8M stabilization interrupt
0: Disable the IRC8M stabilization interrupt
1: Enable the IRC8M stabilization interrupt
9
LXTALSTBIE
LXTAL Stabilization Interrupt Enable
LXTAL stabilization interrupt enable/disable control
0: Disable the LXTAL stabilization interrupt
1: Enable the LXTAL stabilization interrupt
8
IRC40KSTBIE
IRC40K Stabilization interrupt enable
IRC40K stabilization interrupt enable/disable control
0: Disable the IRC40K stabilization interrupt
1: Enable the IRC40K stabilization interrupt
7
CKMIF
HXTAL Clock Stuck Interrupt Flag
Set by hardware when the HXTAL clock is stuck.
Reset by software when setting the CKMIC bit.
0: Clock operating normally
1: HXTAL clock stuck
6
Reserved
Must be kept at reset value
5
IRC28MSTBIF
IRC28M stabilization interrupt flag
Set by hardware when the IRC28M is stable and the IRC28MSTBIE bit is set.
Reset by software when setting the IRC28MSTBIC bit.
0: No IRC28M stabilization interrupt generated
1: IRC28M stabilization interrupt generated
4
PLLSTBIF
PLL stabilization interrupt flag
Set by hardware when the PLL is stable and the PLLSTBIE bit is set.
Reset by software when setting the PLLSTBIC bit.
0: No PLL stabilization interrupt generated
1: PLL stabilization interrupt generated
3
HXTALSTBIF
HXTAL stabilization interrupt flag
Set by hardware when the External 4 ~ 32 MHz crystal oscillator clock is stable and
the HXTALSTBIE bit is set.
Reset by software when setting the HXTALSTBIC bit.
0: No HXTAL stabilization interrupt generated
1: HXTAL stabilization interrupt generated
2
IRC8MSTBIF
IRC8M stabilization interrupt flag
Set by hardware when the Internal 8 MHz RC oscillator clock is stable and the
IRC8MSTBIE bit is set.
Reset by software when setting the IRC8MSTBIC bit.
0: No IRC8M stabilization interrupt generated