1 - 14
Module 4.3 - Cyclone TruSpace
Introduction
Created from a ScanWorld a TruSpace is like a ModelSpace View of a single ScanWorld. In a
TruSpace, you can easily rotate and zoom the view without getting “lost in space”, as the view is
constrained to the scanner location. Users who are familiar with ScanControl will see that the
view in TruSpace is constrained in the same way. Target extraction, viewing of the multi-image
or texture mapped image, importing of modeled objects and view manipulations like cloud point
thickness, and color mapping are all supported in TruSpace; as well as the ability to “jump” to
the position of another ScanWorld’s TruSpace from within the current TruSpace.
Objectives
The objectives of this training module are:
•
Open and view a TruSpace and its associated ModelSpace View and KeyPlan
•
Extract Targets - all or one at a time
•
Synchronize views to an associated ModelSpace
•
Change view settings
•
Jump to another TruSpace and view neighboring TruSpace Icons
•
Perform measurements
•
Place a Quick Limit box
Files to Use
•
Bishop Drive-San Ramon.imp
•
Target extraction.zfs
To Next Page
Loading...
