13 - 14
3 Review
From a TruSpace you can:
•
View the pointcloud in the panoramic mode
•
Change color map
•
Jump to another TruSpace and change the viewing of neighboring TruSpace
Icons
•
Open an associated KeyPlan
•
Open an associated ModelSpace
•
Synchronize the view to an associated ModelSpace
•
Use adaptive point width for visualization
•
Paste objects copied from a ModelSpace (Cylinders, pipes, lines etc)
•
Place a limit box in TruSpace and it opens the associated ModelSpace with the
limit box in place
•
Measure point to point
•
Extract targets - all or one at a time
To Next Page
