1 - 18
Module 5.3 - Alignments & Sections
Introduction
Cyclone has specific tools for creating sections along an alignment, which in most cases is along
a roadway or tunnel. An existing alignment can be imported or created within Cyclone, along
which stations can be created at user specified intervals. Further, sections of point clouds can
then be referenced relative to the established stations.
Objectives
The objectives of this training module are:
•
Cleanup the scan
•
Creating an Alignment
•
Creating and Editing Sections
•
Use of Sections Manager
Files to Use
•
ImolaBridge.imp
•
Alignment.coe
To Next Page
