1 - 8
Module 5.1 - Measurements
Introduction
The objective of this training module is to become familiar with measuring tools in Cyclone
through the use of an exercise using a registered set of scans of an intersection and park area.
For your convenience certain elements of the intersection and park area have already been
modeled.
Objectives
The objectives of this training module will be learning how to:
•
Obtain measurements
•
Edit measurements
•
Save measurements
Files to Use
•
Bishop Drive – San Ramon.imp
Table of Contents
1
Measurements......................................................................................................................... 2
2
Obtaining Measurements......................................................................................................... 4
3
Edit and Save Measurements................................................................................................... 5
3.1
Point-to-Centerline Distance .......................................................................................... 5
3.2
Point to Unbounded Surface .......................................................................................... 6
3.3
Obtaining Multiple Measurements from a Point.............................................................. 7
4
Copying Measurements ........................................................................................................... 8
4.1
Copying Measurements with the Measurements dialog .................................................. 8
4.2
Copying Measurements to the Output Box..................................................................... 8
To Next Page
