Module 2.1 - Point Cloud Import
Introduction
Most scanning hardware offer on-board data acquisition and storage. This means that after the
execution of the field work the data has to be downloaded and opened / imported into
processing software.
The following module describes the steps of importing data acquired onboard with Leica
Geosystems’ ScanStation Series and HDS 7000 into Cyclone.
It also explains the import process and options when importing 3
rd
party scan data as well as
ascii formatted files.
Objectives
The objectives of this training module are learning how to:
•
Import Leica ScanStation data
•
Import HDS 7000 (and previous model) zfs files
•
Import other scan file formats as well as ascii and binary
•
Import Auto Align Project
•
Import MS50 data
•
Using Leica Batch Import
Files to Use
•
none
To Next Page
Loading...
