Leica Cyclone - Page 326

2 - 28 Module 5.2 - Mesh Data Extraction
Table of Contents
1 Mesh Creation and Editing ....................................................................................................... 3
1.1 Create a TIN Mesh.......................................................................................................... 3
1.2 Mesh Editing/ Cleaning ................................................................................................... 5
1.3 Verify TIN ....................................................................................................................... 8
2 Creating Deliverables from Meshes .......................................................................................... 9
2.1 Measuring Volumes ........................................................................................................ 9
2.2 Measure Surface Deviation........................................................................................... 14
2.3 Contour Lines............................................................................................................... 16
3 Enhanced TIN Mesh Creation and Editing ............................................................................... 18
3.1 Defining Breaklines ...................................................................................................... 18
3.2 Creating a TIN Mesh from points and polylines............................................................. 20
3.3 Including additional Breaklines ..................................................................................... 21
3.4 Decimating a TIN Mesh................................................................................................. 23
4 Creating a Uniform Sample Grid Pattern ................................................................................ 27