Dell Force10 MXL Blade - Mac Access-Group

118 | Access Control Lists (ACL)
www.dell.com | support.dell.com
mac access-group
Apply a MAC ACL to traffic entering or exiting an interface.
Syntax
mac access-group access-list-name {in [vlan vlan-range] | out}
Parameters
Defaults
none
Command Modes
INTERFACE
Command
History
Usage
Information
You can assign one ACL (standard or extended) to an interface.
Related
Commands
show mac access-lists
Displays all of the Layer 2 ACLs configured in the system, whether or not they are applied to an
interface, and the count of matches/mismatches against each ACL entry.
Syntax
show mac access-lists [access-list-name] [interface interface] [in | out]
Parameters
Command Modes
EXEC Privilege
Command
History
\
access-list-name
Enter the name of a configured MAC access list, up to 140 characters.
vlan vlan-range
(OPTIONAL) Enter the keyword vlan followed a range of VLANs. Note that this
option is available only with the
in keyword option.
Range: 1 to 4094, 1-2094 for ExaScale (can used IDs 1-4094)
in Enter the keyword in to configure the ACL to filter incoming traffic.
out Enter the keyword out to configure the ACL to filter outgoing traffic.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
mac access-list standard Configures a standard MAC ACL.
mac access-list extended Configures an extended MAC ACL.
access-list-name
Enter the name of a configured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface followed by the one of the following keywords
and slot/port or number information:
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
in | out
Identify whether ACL is applied on ingress or egress side.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module