Dell Force10 MXL Blade - ETS Commands; DCBX Commands

154 | Data Center Bridging
www.dell.com | support.dell.com
ETS Commands
• bandwidth-percentage
• dcb-output
• dcb-policy output
• dcb-policy output stack-unit stack-ports all
• description
• ets mode on
• priority-list
• priority-group
• priority-group qos-policy
• qos-policy-output ets
• scheduler
• set-pgid
• show interface ets
• show qos dcb-output
• show stack-unit stack-ports ets detail
DCBX Commands
• advertise dcbx-appln-tlv
• advertise dcbx-tlv
• dcbx version
• dcbx port-role
• fcoe priority-bits
• iscsi priority-bits
• debug dcbx
• show interface dcbx detail
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the
interface to DCBX peers.
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-tlv {fcoe | iscsi} command.
Parameters
Defaults
Application priority TLVS are enabled to advertise FCoE and iSCSI.
Command Modes
PROTOCOL LLDP
{fcoe | iscsi}
Enter the application priority TLVs, where:
•
fcoe: enables the advertisement of FCoE in application priority TLVs.
•
iscsi: enables the advertisement of iSCSI in application priority TLVs.