Dell Force10 MXL Blade - Snmp-Server Host

588 | Simple Network Management Protocol (SNMP) and Syslog
www.dell.com | support.dell.com
Related
Commands
snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address [traps | informs] [version 1 | 2c | 3] [auth | no auth | priv]
[community-string] [udp-port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [traps | informs] [version 1 | 2c
| 3
] [auth | noauth | priv] [community-string] [udp-port number] [notification-type] command.
Parameters
show snmp group
Displays the group name, security model, view status, and storage type of
each group.
show running-config snmp Displays the SNMP running configuration.
ip-address
Enter the keyword host followed by the IP address of the host (configurable
hosts is limited to 16).
traps (OPTIONAL) Enter the keyword traps to send trap notifications to the specified
host.
Default: traps
informs
(OPTIONAL) Enter the keyword informs to send inform notifications to the
specified host.
Default: traps
version 1 | 2c | 3
(OPTIONAL) Enter the keyword version to specify the security model
followed by the security model version number
1, 2c, or 3.
• Version
1 is the least secure version
• version
3 is the most secure of the security modes.
• Version
2c allows transmission of informs and counter 64, which allows for
integers twice the width of what is normally allowed.
Default: Version
1
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a
packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication and then
scrambling of the packet.
community-string
Enter a text string (up to 20 characters long) as the name of the SNMP
community.
Note: For version 1 and version 2c security models, this string
represents the name of the SNMP community. The string can be set
using this command, however it is recommended that you set the
community string using the snmp-server community command before
executing this command. For version 3 security model, this string is the
USM user security name.