Dell Force10 MXL Blade - Syslog Commands

594 | Simple Network Management Protocol (SNMP) and Syslog
www.dell.com | support.dell.com
Related
Commands
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults
Enabled.
Command Modes
INTERFACE
Command
History
Usage
Information
If the interface is expected to flap during normal usage, you can disable this command.
Syslog Commands
The following commands allow you to configure logging functions on all Dell Force10 switches:
• clear logging
• default logging buffered
• default logging console
• default logging monitor
• default logging trap
• logging
• logging buffered
• logging console
• logging facility
• logging history
• logging history size
• logging monitor
• logging on
• logging source-interface
• logging synchronous
• logging trap
• show logging
• show logging driverlog stack-unit
• terminal monitor
show running-config snmp Displays the SNMP running configuration.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module