66 | Control and Monitoring
www.dell.com | support.dell.com
show processes ipc flow-control
Display the Single window protocol queue (SWPQ) statistics.
Syntax
show processes ipc flow-control [cp]
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
Figure 4-24. show processes ipc flow-control Command Example
Table 4-1 lists the definitions of the fields shown in Figure 4-24.
show interfaces stack-unit Displays information on all interfaces on a specific stack member.
show processes memory Displays CPU usage information based on running processes
cp (OPTIONAL) Enter the keyword cp to view the Control Processor’s SWPQ
statistics.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show processes ipc flow-control
Q Statistics on CP Processor
TxProcess RxProcess Cur High Time Retr Msg Ack Aval Max
Len Mark Out ies Sent Rcvd Retra Retra
ACL0 RTM0 0 0 0 0 0 0 10 10
ACL0 DIFFSERV0 0 0 0 0 0 0 10 10
ACL0 IGMP0 0 0 0 0 0 0 10 10
ACL0 PIM0 0 0 0 0 0 0 10 10
ARPMGR0 MRTM0 0 0 0 0 0 0 100 100
LACP0 IFMGR0 0 0 0 0 0 0 25 25
RTM0 OTM0 0 0 0 0 0 0 60 60
RTM0 OTM0 0 0 0 0 0 0 60 60
FTOS#
Table 4-1. Description of the show processes ipc flow-control cp output Command
Field Description
Source QID /Tx Process Source Service Identifier
Destination QID/Rx Process Destination Service Identifier
Cur Len Current number of messages enqueued
High Mark Highest number of packets in the queue at any point of time
#of to / Timeout Timeout count
#of Retr /Retries Number of retransmissions
#msg Sent/Msg Sent/ Number of messages sent
#msg Ackd/Ack Rcvd Number of messages acknowledged
To Next Page
Loading...
