Dell Force10 MXL Blade - Logging Coredump Server

26 | File Management
www.dell.com | support.dell.com
logging coredump server
Designate a server to upload core dumps.
Syntax
logging coredump server {ipv4-address} username name password [type] password
Parameters
Defaults
Crash kernel files are uploaded to flash by default.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Because flash space may be limited, using this command ensures your entire crash kernel files are
uploaded successfully and completely. Only a single coredump server can be configured.
Configuration of a new coredump server over-writes any previously configured server.
Related
Commands
pwd
Display the current working directory.
Syntax
pwd
Command Modes
EXEC Privilege
Command
History
Example
Figure 3-4. pwd Command Example
Related
Commands
{ipv4-address}
Enter the server IPv4 address (A.B.C.D)
name
Enter a username to access the target server.
type
Enter the password type:
• Enter 0 to enter an unencrypted password.
• Enter 7 to enter a password that has already been encrypted using a Type
7 hashing algorithm.
password
Enter a password to access the target server.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Note: You must disable logging coredump before you designate a new server destination for
your core dumps.
logging coredump Disables the kernel coredump
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#pwd
flash:
FTOS#
cd Changes the directory.