Dell Force10 MXL Blade - Redistribute Ospf; Router Rip

502 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Related
Commands
redistribute ospf
Redistribute routing information from an OSPF process.
Syntax
redistribute ospf process-id [match external {1 | 2} | match internal | metric metric-value]
[route-map map-name]
To disable redistribution, use the no redistribute ospf process-id [match external {1 | 2} | match
internal | metric metric-value] [route-map map-name] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command History
router rip
Enter ROUTER RIP mode to configure and enable RIP.
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults
Disabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To enable RIP, you must assign a network address using the network command.
default-information originate Generates a default route for RIP traffic.
process-id
Enter a number that corresponds to the OSPF process ID to be redistributed.
Range: 1 to 65355.
match external {1 |
2
}
(OPTIONAL) Enter the keywords
match external followed by the numbers 1 or
2 to indicated that external 1 routes or external 2 routes should be redistributed.
match internal (OPTIONAL) Enter the keywords match internal to indicate that internal routes
should be redistributed.
metric metric-value (OPTIONAL) Enter the keyword metric followed by a number as the metric value.
Range: 0 to 16
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of a
configured route map.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module