Dell Force10 MXL Blade - Mac-Address-Table Aging-Time; Mac-Address-Table Static

338 | Layer 2
www.dell.com | support.dell.com
Command Modes
EXEC Privilege
Command
History
mac-address-table aging-time
Specify an aging time for MAC addresses to be removed from the MAC Address Table.
Syntax
mac-address-table aging-time seconds
Parameters
Defaults
1800 seconds
Command Modes
CONFIGURATION
Command
History
Related
Commands
mac-address-table static
Associate specific MAC or hardware addresses to an interface and VLANs.
Syntax
mac-address-table static mac-address output interface vlan vlan-id
To remove a MAC address, use the no mac-address-table static mac-address output interface vlan
vlan-id command.
interface interface
Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
vlan vlan-id Enter the keyword vlan followed by a VLAN ID number from 1 to 4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
seconds
Enter either zero (0) or a number as the number of seconds before MAC addresses are
relearned. To disable aging of the MAC address table, enter 0.
Range: 10 - 1000000
Default: 1800 seconds
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
mac learning-limit Sets the MAC address learning limits for a selected interface.
show mac-address-table aging-time Displays the MAC aging time.