Dell Force10 MXL Blade - Debug Spanning-Tree Mstp

372 | Multiple Spanning Tree Protocol (MSTP)
www.dell.com | support.dell.com
debug spanning-tree mstp
Enable debugging of the multiple spanning tree protocol and view information on the protocol.
Syntax
debug spanning-tree mstp [all | bpdu interface {in | out} | events]
To disable debugging, use the
no debug spanning-tree mstp command.
Parameters
Command Modes
EXEC Privilege
Command
History
Example
Figure 20-1. debug spanning-tree mstp bpdu Command Example
description
Enter a description of the multiple spanning tree protocol.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
none
Command Modes
SPANNING TREE (The prompt is “config-mstp”.)
all (OPTIONAL) Enter the keyword all to debug all spanning tree operations.
bpdu interface {in
| out}
(OPTIONAL) Enter the keyword
bpdu to debug Bridge Protocol Data Units.
(OPTIONAL) Enter the interface keyword along with the type slot/port of the
interface you want displayed. Type slot/port options are the following:
• For a Port Channel interface, enter the keyword port-channel followed by a
number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
Optionally, enter an in or out parameter in conjunction with the optional interface:
• For Receive, enter
in
• For Transmit, enter out
events
(OPTIONAL) Enter the keyword events to debug MSTP events.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#debug spanning-tree mstp bpdu tengigabitethernet 0/16 ?
in Receive (in)
out Transmit (out)
FTOS#
description
Enter a description to identify the Multiple Spanning Tree (80 characters maximum).