Dell Force10 MXL Blade - Show Vrrp

668 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
show config
View the non-default VRRP configuration.
Syntax
show config [verbose]
Parameters
Command Modes
VRRP
Command
History
Example
Figure 38-1. show config Command Example
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns “No
Active VRRP group
.”
Syntax
show vrrp [vrrp-id] [interface] [brief]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group configuration
information, including defaults.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
vrrp-id
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to view only that
group.
Range: 1 to 255.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For Port Channel interface types, enter the keyword
port-channel followed by the
number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by the VLAN ID. The VLAN
ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module